Using FreeJoyQT software with G-FORCE CP-Series control panels 

1/ NOT CHANGE CONFIGURATION IN PIN CONFIG SECTION! NOT CHANGE FIRMWARE VERSION!

2/ Load configuration from your panel to FreeJoy sofware and backup config file in your computer as init backup file. Archive this file in case of restoring the correct functionality of the control panel.

3/ After loading configuration check PID and VID numbers in section Advanced Setup. The PID number is last 4 digit of serial number. The serial number is located on the back side of your controller.

4/ For CP series control panels is possible to configure in the sections Button Config, Encoders, Axes Config, Curves Config and Advance Setting. Settings in other sections are not supported. The programming options for each model may be different.

5/ If you want to experiment with the controller settings, we recommend changing only the function and timer item in the button config section. Changing the mapping of the physical buttons will result incorrect functionality of the controls elements (buttons, switches, encoders).

NOTE: The correct function of the control panel is guaranteed only with the factory configuration. How to save the configuration file is described in point 2.

CAUTION! Flashing firmware or change configuration settings is at the customer’s own risk, and the manufacturer does not provide any warranty for incorrect device functionality. For recovery of functionality of your controller load factory configuration file and write it to device. We do not recommend flashing the firmware, you risk the complete non-functionality of your device. Fixing a firmware crash requires a professional service repair.